890370_0•en•01.06.2009
We reserve the right to carry out improvements
106
WAREMA climatronic
®
Installation Instructions
No manual operation
This setting completely excludes manual operation on the local pushbuttons
and on the control panel.
Dead man
With this setting, the sun shading product moves in the desired direction until
the button is released again.
Permanent mode
This control option is useful for roller shutters and fabric products. The prod-
uct is raised immediately after the "Up" button is pushed. The drive stops
when the "Down" button is pushed during raising.
The product is lowered immediately after the"Down" button is pushed. The
drive stops when the "Up" button is pushed during lowering.
The product can also be stopped at any time using the stop button in the
centre.
Radio time mode
This mode is useful for slat products: By briefly activating (<0.6seconds)
the "Up" or "Down" button you can adjust the sun shading product in small
steps. This function can be used with slat products to tilt the slats. If the but-
ton continues to be activated beyond this, the radio time mode switches to
the lock mode. The button may then be released. The sun shading product
moves until the run time has elapsed. To release the lock and stop the motor,
the button for the opposite direction of movement or the stop button must be
pressed.
Continuous mode
The control option is useful for lighting equipment: The [ON] and [OFF] but-
tons on the control panel can be used to switch the light on and off. If a
hand-held or wall-mounted transmitter was learned in for the light channel,
the light can be switched on and off using the B button (=lighting).
Toggle mode (3 steps)
This control option is suitable for a fan that can be switched to three different
steps.
Dim/adjust mode
This control option is suitable for dimmable lighting systems. A brief opera-
tion of the button switches the light on or off. If you press and hold the but-
ton, the light is dimmed up or down until you release the button again.
The same logic mode is also used with an infinitely variable, dimmable fan.
Stair light function
This control option is especially suited for stair lighting systems. A press of
the button switches the light on for an adjustable period of several minutes
and then switches it off again automatically. If the button pressed again dur-
ing this time, the lights-on period starts from the beginning.
Products
To Next Page
Loading...