WAREMA climatronic - Allocating the Products to the Inputs and Outputs

890370_0•en•01.06.2009
We reserve the right to carry out improvements
34
WAREMA climatronic
®
Installation Instructions
5.3 Allocating the
products to the inputs
and outputs
The allocation of the products to the switch actuator inputs and outputs can
be freely selected.
Use the following tables to note down information and mark crosses where
appropriate (e.g. "E 1.1", "V1"). These tables can be found on the last page
of the switch actuator instructions. Also affix an ID sticker of the actuator on
the field provided for this purpose and note down the installation location and
any additional information on the device, if necessary.
Switch actuator 6M
Block
Out-
put
Product Used inputs
Output locked using Group formation using
V1 V2 V3 V4 V5 V6 V1 V2 V3 V4 V5 V6
X2
A1.1 E1.1
A1.2 E1.2
A2.1 E2.1
A2.2 E2.2
X3
A3.1 E3.1
A3.2 E3.2
A4.1 E4.1
A4.2 E4.2
X4
A5.1 E5.1
A5.2 E5.2
A6.1 E6.1
A6.2 E6.2
Switch actuator 4M
Block
Out-
put
Product Used inputs
Output locked
using
Group formation
using
V1 V2 V3 V4 V1 V2 V3 V4
X2
A1.1 E1.1
A1.2 E1.2
A2.1 E2.1
A2.2 E2.2
X3
A3.1 E3.1
A3.2 E3.2
A4.1 E4.1
A4.2 E4.2
NOTE The outputs for one product are always located on the same terminal block.
Note also the information in the operating and installation instructions of the
respective switch actuator.
Connection information