890370_0•en•01.06.2009 We reserve the right to carry out improvements
47
6.2 Typical approaches for
commissioning
The WAREMA climatronic allows for different approaches to commissioning.
Depending on the complexity of the building project, commissioning may
take place via:
The commissioning assistant on the control panel
It guides you to a finished project with the basic settings in just a few steps.
During the setup procedure, the most important parameters can be viewed
and changed. After this, they merely need to be transferred to the connected
devices (sensors and actuators).
Manual commissioning
For complex building projects with special requirements and settings, it may
be useful to perform a manual commissioning.
Proceed in this sequence:
Create actuators, create channels, create products, allocate products to the
channels and the contacts of the actuators, create sensors, load data into
the devices, set the parameters for the comfort and safety functions.
NOTE You can also use the assistant to create the basic framework of your project
and then continue by adjusting your preferences and circumstances manu-
ally.
WAREMA climatronic studio software manual
With the climatronic studio software, you can fully create and parameterise a
project on a PC. Furthermore, you can make additional settings and adjust-
ments on the climatronic. The software and the associated documentation
can be found on the supplied CD-ROM.
After the project data have been stored in the WAREMA climatronic, they are
uploaded to the connected bus devices (actuators, weather stations and hu-
midity/temp. sensors).
The system is now ready for operation.
Overview
To Next Page
Loading...