WAREMA climatronic - Table of Contents

890370_0•en•01.06.2009 We reserve the right to carry out improvements
3
Contents
1 Legal notes ....................................................................................................... 7
2 Safety instructions ........................................................................................... 8
2.1 Meanings of symbols and pictographs ...........................................................8
2.2 Intended use ......................................................................................................... 9
2.3 Target group .......................................................................................................10
2.4 Retrofitting and modifications ...........................................................................10
2.5 Working safely .....................................................................................................11
2.6 Additional documents ........................................................................................12
2.7 Basic software versions .....................................................................................12
3 Introduction .................................................................................................... 13
3.1 Operating elements and interfaces .................................................................13
3.2 Principal structure of a WAREMA climatronic system .................................14
3.3 Concept ................................................................................................................15
3.3.1 Pyramid diagram of products, channels, groups, scenes ....................16
3.3.2 Channels, facades and products .............................................................17
3.3.3 Groups ............................................................................................................18
3.3.4 Scenes ............................................................................................................18
4 Installation ...................................................................................................... 19
4.1 Accessory box .....................................................................................................19
4.2 Procedure ............................................................................................................ 20
4.3 Planning the network structure .......................................................................21
4.3.1 The serial number ........................................................................................ 23
4.3.2 Sizing the power supply ............................................................................ 25
4.3.3 Use of repeaters and hubs ....................................................................... 28
4.3.4 Network cables ........................................................................................... 28
4.4 Installing the control panel .............................................................................. 28
4.5 Installing the switch actuators ........................................................................ 30
5 Connection information ................................................................................. 31
5.1 Switch actuator outputs ................................................................................... 32
5.2 Local group pushbuttons ................................................................................. 33
5.3 Allocating the products to the inputs and outputs ...................................... 34
5.4 Connection examples ...................................................................................... 35
6 Overview ......................................................................................................... 45
6.1 Elements of the display .................................................................................... 45
6.1.1 Start menu .................................................................................................... 45
6.1.2 Status display ............................................................................................... 46
6.2 Typical approaches for commissioning .........................................................47
7 Commissioning ............................................................................................. 48
7.1 Setting the operating language ...................................................................... 48
7.2 Project setup with the assistant ..................................................................... 49
7.2.1 Creating a sensor ........................................................................................51
7.2.2 Identifying a sensor .................................................................................... 52
7.2.3 Creating actuators ...................................................................................... 55
7.2.4 Identifying actuators .................................................................................... 56
7.2.5 Creating channels ........................................................................................ 59
7.2.5.1 Assigning name for channel X ............................................................ 59
7.2.5.2 Selecting a product type ..................................................................... 60
7.2.5.3 Setting the number of products to be controlled together ............ 60
7.2.5.4 Selecting an external venetian blind type .........................................61
Table of contents