890370_0•en•01.06.2009 We reserve the right to carry out improvements
71
When you return to the main menu after commissioning is completed, a
wrench appears at the upper right in the header:
This wrench is visible for 1 hour because you logged in as a dealer earlier.
The dealer menus can be accessed during this time to perform additional
settings without having to entering the password again.
End the dealer mode with [Main menu] > [Settings] > [Authorised dealer]
> [End authorised dealer access].
NOTE After an interruption in the power supply, the dealer mode is no longer active.
However, changes made to the parameterisation are retained.
To enable these changes to be called up with the [Restore settings] func-
tion again at any time, you should enter the dealer mode again and save
them using [Assume settings] or when leaving the dealer mode.
Assistant
To Next Page
Loading...