5/2011
4-90
Phaser 4600/4620 Printer Service Manual
REP 10.6, REP 10.7
Revision - Xerox Internal Use Only
Repairs
Figure 7 Remove the Exit Assembly
REP 10.7 Stack Full Sensor
Parts List on PL 10.30 Item 9
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. Remove the Duplex Unit, REP 10.1.
2. Remove the IP Board Cover, REP 28.1.
3. Remove the Right Cover, REP 28.2.
4. Remove the Waste Toner Cartridge.
5. Remove the Left Cover, REP 28.3.
6. Remove the Top Cover, REP 28.5.
7. Remove 5 screws (2 plastic, 3 metal) that secure the rear support bracket to the chassis.
8. Lift the bracket and rest on the printer chassis, Figure 1.
Figure 1 Remove the rear support bracket
9. Remove 4 screws (plastic) that secure the Exit Chute to the chassis.
To Next Page
Loading...
