Xerox Phaser 4620 - REP 12.18 Finisher Top Cover; REP 12.19 Tamper Motor

5/2011
4-142
Phaser 4600/4620 Printer Service Manual
REP 12.18, REP 12.19
Revision - Xerox Internal Use Only
Repairs
REP 12.18 Finisher Top Cover
Parts List on PL 12.10 Item 6
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. Separate the Finisher from the printer, GP 14.
2. Remove the right cover, REP 12.11.
3. Remove the left cover, REP 12.1.
4. Remove 4 screws (plastic) that secure the top cover to the Finisher, Figure 1.
Figure 1 Remove the top cover
REP 12.19 Tamper Motor
Parts List on PL 12.35 Item 19
Removal
WARNING
Switch off the electricity to the machine. Disconnect the power cord from the customer
supply while performing tasks that do not need electricity. Electricity can cause death or
injury. Moving parts can cause injury.
1. Separate the Finisher from the printer, GP 14.
2. Remove the right cover, REP 12.11.
3. Remove the left cover, REP 12.1.
4. Remove the top cover, REP 12.18.
5. Disconnect the affected Tamper Motor.
6. Remove 2 screws (metal) that secure the Tamper Motor to the Finisher.
7. Slide the motor to feed the gear through the bracket opening, Figure 1.
Figure 1 Remove the Tamper Motor