Yamaha FJR1300A(D) - Removing the Front Wheel; Disassembling the Front Wheel; Checking the Front Wheel

FRONT WHEEL
4-25
EAS21900
REMOVING THE FRONT WHEEL
NOTICE
ECA1MC1028
Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the front wheel hub “1”, otherwise the
wheel sensor rotor equipped in the wheel
hub may be damaged, resulting in improper
performance of the ABS and UBS.
1. Stand the vehicle on a level surface.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Remove:
• Front wheel sensor
• Front brake calipers
NOTICE
ECA1MC1015
Do not operate the brake lever or the brake
pedal when removing the brake calipers.
3. Elevate:
• Front wheel
TIP
Place the vehicle on a suitable stand so that the
front wheel is elevated.
EAS21910
DISASSEMBLING THE FRONT WHEEL
NOTICE
ECA3P6D003
• Keep magnets (including magnetic pick-up
tools, magnetic screwdrivers, etc.) away
from the wheel sensor rotor.
• Do not drop the wheel sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the wheel sensor ro-
tor, wipe it off immediately.
1. Remove:
• Oil seals
• Wheel bearings
▼▼▼▼ ▼ ▼▼▼▼▼▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Clean the surface of the front wheel hub.
b. Remove the oil seals “1” with a flathead
screwdriver.
TIP
To prevent damaging the wheel or wheel sensor
rotor, place a rag “2” between the screwdriver
and the surface of the wheel or rotor.
c. Remove the wheel sensor rotor.
d. Remove the wheel bearings “3” with a gener-
al bearing puller.
▲▲▲▲ ▲ ▲▲▲▲▲▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
EAS21920
CHECKING THE FRONT WHEEL
1. Check:
• Wheel axle
Roll the wheel axle on a flat surface.
Bends → Replace.
WARNING
EWA13460
Do not attempt to straighten a bent wheel ax-
le.
1