ENGINE SPECIFICATIONS
2-2
EAS20290
ENGINE SPECIFICATIONS
Engine
Engine type Liquid cooled 4-stroke, DOHC
Displacement 1298.0 cm³
Cylinder arrangement Inline 4-cylinder
Bore × stroke 79.0 × 66.2 mm (3.11 × 2.61 in)
Compression ratio 10.80 : 1
Standard compression pressure (at sea level) 1600 kPa/400 r/min (16.0 kgf/cm²/400 r/min,
227.6 psi/400 r/min)
Minimum-maximum 1390–1790 kPa (13.9–17.9 kgf/cm², 197.7–
254.6 psi)
Starting system Electric starter
Fuel
Recommended fuel Regular unleaded gasoline only (Europe)
Unleaded gasoline only (AUS)
Fuel tank capacity 25.0 L (6.61 US gal, 5.50 Imp.gal)
Fuel reserve amount 5.5 L (1.45 US gal, 1.21 Imp.gal)
Engine oil
Lubrication system Wet sump
Recommended brand YAMALUBE
Type SAE 10W-40, 10W-50, 15W-40, 20W-40 or
20W-50
Recommended engine oil grade API service SG type or higher, JASO standard
MA
Engine oil quantity
Total amount 4.90 L (5.18 US qt, 4.31 Imp.qt)
Without oil filter cartridge replacement 3.80 L (4.02 US qt, 3.34 Imp.qt)
With oil filter cartridge replacement 4.00 L (4.23 US qt, 3.52 Imp.qt)
Oil pressure 30.0 kPa/1050 r/min (0.30 kgf/cm²/1050 r/min,
4.4 psi/1050 r/min) at oil temperature of 85.0 °C
(185.0 °F)
Final gear oil
Type Shaft drive gear oil (Part No.: 9079E-SH002-00)
Quantity 0.20 L (0.21 US qt, 0.18 Imp.qt)
Oil filter
Oil filter type Cartridge
Oil pump
Oil pump type Trochoid
Inner-rotor-to-outer-rotor-tip clearance Less than 0.12 mm (0.0047 in)
Limit 0.20 mm (0.0079 in)
Outer-rotor-to-oil-pump-housing clearance 0.09–0.15 mm (0.0035–0.0059 in)
Limit 0.22 mm (0.0087 in)
Oil-pump-housing-to-inner-and-outer-rotor
clearance 0.06–0.11 mm (0.0024–0.0043 in)
Limit 0.18 mm (0.0071 in)
To Next Page
Loading...
