Yamaha FJR1300A(D) - Page 519

FUEL INJECTION SYSTEM
8-70
Meter display
Clutch switch
• “ON” (when the clutch lever is squeezed with the transmission in
gear and when the sidestand is retracted)
• “OFF” (when the clutch lever is squeezed with the transmission
in gear and when the sidestand is extended)
Procedure Operate the transmission, clutch lever, and sidestand.
Item
Probable cause of mal-
function and check
Maintenance job
Confirmation of service
completion
1 Locate the malfunction. Execute the diagnostic
mode. (Code No. 07)
Rotate the rear wheel by
hand and check that the indi-
cated value increases.
Value does not increase →
Go to item 2 in section A for
the rear wheel sensor.
Execute the diagnostic
mode. (Code No. 21)
When the transmission is in
neutral: “ON”
When the transmission is in
gear with the clutch lever re-
leased: “OFF”
Incorrect indication → Go to
item 2 in section B for the
neutral switch.
When the transmission is in
gear with the clutch lever
squeezed and the sidestand
retracted: “ON”
Incorrect indication → Go to
item 2.
2 Clutch lever adjustment. Refer to “ADJUSTING THE
CLUTCH LEVER” on page
3-12.
Execute the diagnostic
mode. (Code No. 21)
When the clutch lever is re-
leased: “OFF”
When the clutch lever is
squeezed: “ON”
Correct indication→ Go to
item 9.
Incorrect indication → Go to
item 3.
3 Connection of clutch switch
coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
Execute the diagnostic
mode. (Code No. 21)
When the clutch lever is re-
leased: “OFF”
When the clutch lever is
squeezed: “ON”
Correct indication→ Go to
item 9.
Incorrect indication → Go to
item 4.
Fault code No. 42
Item
A
Rear wheel sensor: no normal signals are received from the
rear wheel sensor.
B Neutral switch: open or short circuit is detected.
C Clutch switch: open or short circuit is detected.