EasyManua.ls Logo

Yamaha FJR1300A(D) - Page 530

Yamaha FJR1300A(D)
662 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
FUEL INJECTION SYSTEM
8-81
4 Connection of wire harness
ECU coupler.
Check the locking condition
of the coupler.
Disconnect the coupler and
check the pins (bent or bro-
ken terminals and locking
condition of the pins).
Improperly connected →
Connect the coupler secure-
ly or replace the wire har-
ness.
Execute the diagnostic
mode. (Code No. 16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Go to
item 9 and delete the fault
code.
Value does not increase →
Go to item 5.
5 Wire harness continuity. Open or short circuit → Re-
place the wire harness.
Between front wheel sensor
coupler and ABS ECU cou-
pler.
black–black
white–white
Between ABS ECU coupler
and ECU coupler.
blue/yellow–blue/yellow
Execute the diagnostic
mode. (Code No. 16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Go to
item 9 and delete the fault
code.
Value does not increase →
Go to item 6.
6 Defective front wheel sensor. Improperly installed sensor
→ Reinstall or replace the
sensor.
Execute the diagnostic
mode. (Code No. 16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Go to
item 9 and delete the fault
code.
Value does not increase →
Go to item 7.
7 Malfunction in ECU. Replace the ECU.
Refer to “REPLACING THE
ECU (engine control unit)” on
page 8-174.
Execute the diagnostic
mode. (Code No. 16)
Rotate the front wheel by
hand and check that the indi-
cated value increases.
Value increases → Go to
item 9 and delete the fault
code.
Value does not increase →
Go to item 8.
8 Malfunction in ABS ECU. Replace the ABS ECU. Go to item 9.
Fault code No. 69
Item
Front wheel sensor: no normal signals are received from the
front wheel sensor.

Table of Contents