14.2 Parameter Recording Table
14-40
* The enable timing depends on the digit that is changed. Refer to the following section for details.
14.1 List of Parameters on page 14-2
Pn52A 20
Multiplier per Fully-closed
Rotation
Immediately
Pn52B 20 Overload Warning Level Immediately
Pn52C 100
Base Current Derating at
Motor Overload Detection
After restart
Pn52F 0FFF hex Monitor Display at Startup Immediately
Pn530 0000 hex
Program Jogging-Related
Selections
Immediately
Pn531 32768
Program Jogging Travel
Distance
Immediately
Pn533 500
Program Jogging Move-
ment Speed
Immediately
Pn534 100
Program Jogging Accelera-
tion/Deceleration Time
Immediately
Pn535 100
Program Jogging Waiting
Time
Immediately
Pn536 1
Program Jogging Number
of Movements
Immediately
Pn550 0
Analog Monitor 1 Offset
Voltage
Immediately
Pn551 0
Analog Monitor 2 Offset
Voltage
Immediately
Pn552 100
Analog Monitor 1 Magnifi-
cation
Immediately
Pn553 100
Analog Monitor 2 Magnifi-
cation
Immediately
Pn55A 1
Power Consumption Moni-
tor Unit Time
Immediately
Pn560 400
Residual Vibration Detec-
tion Width
Immediately
Pn561 100 Overshoot Detection Level Immediately
Pn580 10 Zero Clamping Level Immediately
Pn581 20 Zero Speed Level Immediately
Pn582 10
Speed Coincidence Detec-
tion Signal Output Width
Immediately
Pn583 10
Brake Reference Output
Speed Level
Immediately
Pn584 10000
Speed Limit Level at Servo
ON
Immediately
Pn585 50
Program Jogging Move-
ment Speed
Immediately
Pn586 0
Motor Running Cooling
Ratio
Immediately
Pn600 0
Regenerative Resistor
Capacity
Immediately
Pn601 0
Dynamic Brake Resistor
Allowable Energy Con-
sumption
After restart
Pn603 0 Regenerative Resistance Immediately
Pn604 0 Dynamic Brake Resistance After restart
Pn61A
0000 hex
Overheat Protection Selec-
tions
After restart
Pn61B
250 Overheat Alarm Level Immediately
Pn61C
100 Overheat Warning Level Immediately
Pn61D
0 Overheat Alarm Filter Time Immediately
Continued from previous page.
Parameter
No.
Default Setting Name
When
Enabled
To Next Page
Loading...
