1.6 Functions
1-12
1.6
Functions
This section lists the functions provided by SERVOPACKs. Refer to the reference pages for
details on the functions.
•
Functions Related to the Machine
Function Reference
Power Supply Type Settings for the Main Circuit
and Control Circuit
page 5-14
Automatic Detection of Connected Motor
page 5-16
Motor Direction Setting
page 5-18
Linear Encoder Pitch Setting
page 5-19
Writing Linear Servomotor Parameters
page 5-20
Selecting the Phase Sequence for a Linear Ser-
vomotor
page 5-24
Polarity Sensor Setting
page 5-26
Polarity Detection
page 5-27
Overtravel Function and Settings
page 5-31
Holding Brake
page 5-36
Motor Stopping Methods for Servo OFF and
Alarms
page 5-41
Resetting the Absolute Encoder
page 5-51
Setting the Origin of the Absolute Encoder
page 5-54
Setting the Regenerative Resistor Capacity
page 5-57
Operation for Momentary Power Interruptions
page 6-13
SEMI F47 Function
page 6-14
Setting the Motor Maximum Speed
page 6-16
Multiturn Limit Setting
page 6-82
Adjustment of Motor Current Detection Signal
Offset
page 6-102
Forcing the Motor to Stop
page 6-106
Speed Ripple Compensation
page 8-60
Current Control Mode Selection
page 8-73
Current Gain Level Setting
page 8-73
Speed Detection Method Selection
page 8-74
Fully-Closed Loop Control
page 10-1
Safety Functions
page 11-1
To Next Page
Loading...
