15.2 Parameter Recording Table
15-33
* The enable timing depends on the digit that is changed. Refer to the following section for details.
15.1 List of Parameters on page 15-2
PnB2B 4000000 Deceleration Rate Immediately
PnB40 4
Time Constant for Expo-
nential Acceleration/Decel-
eration
Immediately
PnB41 0
Exponential Acceleration/
Deceleration Bias Speed
Immediately
PnB42 25
Average Movement Time
Filter Time Constant
Immediately
PnB50 5
Positioning Completed
Width
Immediately
PnB51 0
Positioning Completion
Timeout Time
Immediately
PnB54 400000
Positioning Approach
Speed
Immediately
PnB55 0End PositionImmediately
PnB59 0000h Approach Mode Immediately
PnBA3 0000h Input Signal Logic Setting Immediately
PnBA4 00A3h Input Signal Setting Immediately
PnBA5 0000h Action Definition Setting After restart
PnBA7 0000h Initialization Setting After restart
PnBA9 10000 Reserved parameter −
PnBAA 4000000 Reserved parameter −
PnBAB 4000000 Reserved parameter −
Continued from previous page.
Parameter
No.
Default
Setting
Name
When
Enabled
To Next Page
Loading...
