9.2 Modes 200
9.2.1 Identification mode 200
9.2.2 Actual signals mode 202
9.2.2.1 Overview 202
9.2.2.2 Selecting the actual signals display 203
9.2.2.3 Toggling between actual signals display and fault
memory 204
9.2.2.4 Displaying three actual signals 204
9.2.2.5 Selecting actual signals 204
9.2.2.6 Displaying a fault and resetting the fault memory 206
9.2.2.7 Displaying and resetting an active fault 208
9.2.3 Parameters mode 209
9.2.3.1 Overview 210
9.2.3.2 Changing a parameter setting 211
9.2.3.3 Enabling / unlocking a parameter lock 213
9.2.3.4 User lock 213
9.2.4 Functions mode 214
9.2.4.1 Adjusting the display contrast 214
9.2.5 Local and remote control mode 216
9.2.5.1 Local control 216
9.2.5.2 Disabling / enabling local lock function 216
9.2.5.3 Enabling the local lock 217
9.2.5.4 Remote control 217
9.3 Operational commands 218
9.3.1 Setting the direction of rotation 218
9.3.2 Entering a reference value 219
10. Preventive and corrective maintenance 221
10.1 General information 221
To Next Page
Loading...
