Commissioning of the KNX Function via DCA (from ETS5)
Product manual 2CKA00xx73xxxxx
59
■
Long. [ddd.dd][+ = East, − = West]
Options: Setting option from +180.00 to -180.00
The parameter is used to set the geographic longitude for the location of the device (180° East
to 180° West)
This setting is important for the astro function.
Notice
Whether a dot or a comma is to be used as decimal separator depends on the
system. If a wrong separator is used, the decimal places cannot be entered as
desired, or the value entered is replaced by a standard value after the entry.
If the entry is made in decimal degrees for example, the angular minutes are specified as
number of decimal places: 1 degree corresponds to 60 minutes.
For example:
7°36′ 13' East (7 degrees, 34 minutes 13 seconds East) = 7.60 decimal degrees
Example of calculation:
13' (seconds) divided by 60 = 0.22' (minutes)
36' (minutes) + 0.22' (minutes) = 36.22' (minutes)
36.22' (minutes) divided by 60 = 0.603' (degrees)
7° (degrees) + 0.603° (degrees) = 7.603° (degrees)
Notice
Negative values are entered with a minus character.
To Next Page
Loading...
