EN50131 Requirement (and relevant section) Relevant Vanderbilt documentation
Maximum current rating of each electrical output Technical data:
l
SPC42/52
l
SPC53
l
SPC63
Programmable functions provided Engineer programming via the keypad on
page66
Engineer programming via the browser on
page122
How indications are made inaccessible to level 1 users when
level 2, 3 or 4 user is no longer accessing the information (see
8.5.1)
Keypad user interface on page52
LCD Keypad Settings on page79
Comfort Keypad Settings on page80
Configuring an Indicator Expander on page162
Masking/reduction of range signals/messages processed as
“fault” or “masking” events (see 8.4.1, 8.5.1 and Table 11)
on page169
Wiring the zone inputs on page45
SIA Codes on page267
PIR masking is always reported as a zone
masked event (SIA - ZM). Additionally, anti-
mask can cause an alarm, tamper, trouble or no
additional action depending on configuration.
Current defaults of PIR addition effect:
Ireland
Unset - None
Set - Alarm
UK, Europe, Sweden, Swiss, Belgium
Unset - Tamper
Set - Alarm
Prioritization of signal and message processing and
indications (see 8.4.1.2, 8.5.3)
Using the LCD keypad interface on page54
Using the Comfort keypad interface - see About
the Comfort keypad
Minimum number of variations of PIN codes, logical keys,
biometric keys and/or mechanical keys for each user (see 8.3)
User PIN combinations on page275
Method of time-limiting internal WD for level 3 access without
level 2 authorization (see 8.3.1)
Not supported - Engineer cannot access
system without permission.
Number and details of disallowed PIN codes (see 8.3.2.2.1) Automatic inhibits on page275
Details of any biometric authorization methods used (see
8.3.2.2.3)
Not applicable
Method used to determine the number of combinations of PIN
codes, logical keys, biometric keys and/or mechanical keys
(see 11.6)
User PIN combinations on page275
SPC42/52/53/63 – Installation & Configuration Manual Directives and standards
© Vanderbilt 2023 16 I-200572
08.12.2023
To Next Page