Alcatel-Lucent 7750 SR OS - Page 1202

VPRN Service Configuration Commands
Page 1202 7750 SR OS Services Guide
IP Addr/mask Pref Metric Type Nexthop Interface Active
------------------------------------------------------------------------------
192.168.254.0/24 4 1 BH black-hole n/a Y
==============================================================================
*A:ALA-12#
*A:ALA-12# show router 3 static-route next-hop 10.10.0.254
==============================================================================
Route Table
==============================================================================
IP Addr/mask Pref Metric Type Nexthop Interface Active
------------------------------------------------------------------------------
192.168.253.0/24 5 1 NH 10.10.0.254 n/a N
=============================================================================
*A:ALA-12#
tunnel-table
Syntax tunnel-table [ip-address[/mask] [protocol protocol | sdp sdp-id]
tunnel-table
[summary]
Context show>router
Description This command displays tunnel table information.
Note that auto-bind GRE tunnels are not displayed in show command output. GRE tunnels are not the
same as SDP tunnels that use the GRE encapsulation type. When the auto-bind command is used
when configuring a VPRN service, it means the MP-BGP NH resolution is referring to core routing
instance for IP reachability. For a VPRN service this object specifies the lookup to be used by the
routing instance if no SDP to the destination exists.
Parameters [ip-address[/mask]] — Displays the specified tunnel table’s destination IP address and mask.
protocol protocol — Displays LDP protocol information.
sdp sdp-id — Displays information pertaining to the specified SDP.
summary — Displays summary tunnel table information.
Output Show Tunnel Table Output — The following table describes tunnel table output fields:
Label Description
Destination
The route’s destination address and mask.
Owner
Specifies the tunnel owner.
Encap
Specifies the tunnel’s encapsulation type.
Tunnel ID
Specifies the tunnel (SDP) identifier.
Pref
Specifies the route preference for routes learned from the configured
peer(s).
Nexthop
The next hop for the route’s destination.