Virtual Leased Line Services
7750 SR OS Services Guide Page 153
vc-type
Specifies a 15 bit value that defines the type of the VC signaled to the
peer.
236
Configure Apipe service parameters
config>service>apipe#
description
Specifies a text string describing the service. 234
interworking
Specifies the interworking function that should be applied for packets
that ingress/egress SAPs that are part of an Apipe service.
239
service-mtu
Configures the MTU to be used for this service. 239
no shutdown
Administratively enables the Apipe service. 233
Configure Apipe SAP parameters
config>service>apipe# sap
accounting-policy
Specifies the accounting policy to apply to the SAP. 248
collect-stats
Enables the collection of accounting and statistical data for the SAP or
network port.
248
egress
Enables a context to configure egress SAP Quality of Service (QoS)
policies.
249
ingress
Enables a context to configure ingress SAP Quality of Service (QoS)
policies.
249
qos
Associates a Quality of Service (QoS) policy with an ingress or egress
Service Access Point (SAP).
251
queue-override
Enables the context to configure override values for the specified SAP
egress QoS queue.
252
queue
Specifies the ID of the queue whose parameters are to be overridden. 252
avg-frame-overhead
Configures the average frame overhead to define the average
percentage that the offered load to a queue will expand during the
frame encapsulation process before sending traffic on-the-wire.
254
adaptation-rule
Specifies attributes of the adaptation rule parameters. 253
cbs
Specifies attributes of the CBS parameters. 255
high-prio-only
Specifies attributes of the high-prio-only parameters. 256
mbs
Specifies attributes of the MBS parameters. 257
rate
Specifies attributes of the Peak Information Rate (PIR) and the
Committed Information Rate (CIR) parameters.
258
scheduler-policy
Applies an existing scheduler policy to an ingress or egress scheduler
used by SAP queues associated with a multi-service customer site.
262
multi-service-site
Associates a customer site with the customer-site-name parameter. 246
no shutdown
Administratively enables the SAP. 233
Table 1: CLI Commands to Configure VLL Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
