Configuring a VLL Service with CLI
Page 154 7750 SR OS Services Guide
Configure Apipe SAP ATM parameters
config>service>apipe>sap# atm
atm
Enables access to the context to configure ATM-related attributes. 274
egress
Configures egress ATM attributes for the SAP. 274
traffic-desc
Assigns an ATM traffic descriptor profile to a given context (for
example a SAP).
275
ingress
Configures ingress ATM attributes for the SAP. 274
oam
Enables the context to configure OAM functionality for a PVCC
delimiting a SAP.
276
alarm-cells
Configures AIS/RDI fault management on a PVCC. 276
terminate
Specifies whether this SAP will act as an OAM termination point.
ATM SAPs can be configured to tunnel or terminate OAM cells.
277
Configure Apipe spoke SDP parameters
config>service>apipe# spoke-sdp sdp-id:vc-id [no-endpoint]
config>service>apipe# spoke-sdp sdp-id:vc-id [endpoint endpoint-name] [icb]
cell-concatenation
Enables the context to provide access to the various options that
control the termination of ATM cell concatenation into an MPLS
frame. Several options can be configured simultaneously.
269
aal5-frame-aware
Enables the AAL5 end-of-message (EOM) to be an indication to
complete the cell concatenation operation.
269
clp-change
Enables the CLP change to be an indication to complete the cell
concatenation operation.
269
max-cells
Enables the configuration of the maximum number of ATM cells to
accumulate into an MPLS packet.
269
max-delay
Enables the configuration of the maximum amount of time to wait
while performing ATM cell concatenation into an MPLS packet
before transmitting the MPLS packet.
270
control-word
Specifies whether the use of the control word is preferred or not.
127
egress
Configures the egress spoke SDP context. 271
ingress
Configures the ingress spoke SDP context. 271
precedence
Specifies the precedence of this SDP bind when there are multiple
SDP binds attached to one service endpoint.
128
vc-label
Configures the egress or ingress VC label. 272
no shutdown
Administratively enables the spoke SDP binding 233
Configure an Fpipe service
Table 1: CLI Commands to Configure VLL Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
