Internet Enhanced Services
7750 SR OS Services Guide Page 685
circuit-id
Enables sending of the interface index in the circuit-id suboption of the
DHCP relay packet.
742
remote-id
Enables sending of the remote MAC address in the remote-id suboption of
the DHCP relay packet.
744
match-circuit-id
Enables Option 82 circuit ID on relayed DHCP packet matching only in
the config>service>ies>sub-if>grp-if>dhcp context.
743
Configure IES interface ICMP parameters
config>service>ies>interface
config>service>ies>sub-if>grp-if>icmp
icmp
Configures ICMP parameters on an IES or VPLS IP interface. 749
mask-reply
Enables responses to ICMP mask requests on the router interface. 749
redirects
Enables and configures the rate for ICMP redirect messages issued on the
router interface.
749
ttl-expired
Configures the rate ICMP TTL expired messages are issued by the IP
interface.
750
unreachables
Enables and configures the rate for ICMP host and network destination
unreachable messages issued on the router interface.
750
Configure VRRP parameters 698
config>service>ies>interface
authentication-key
Assigns a simple text password authentication key to generate master
VRRP advertisement messages and validate received VRRP advertisement
messages.
795
authentication-type
Assigns the authentication method to generate master VRRP advertise-
ment messages and validate received VRRP advertisement messages.
796
backup
Configures virtual router IP addresses for the interface. 798
mac
Assigns a specific MAC address to an IES or VPLS IP interface. 798
master-int-inherit
Allows the master instance to dictate the master down timer (non-owner
context only).
798
message-interval
Sets the advertisement timer and indirectly sets the master down timer on
the virtual router instance.
799
ping-reply
Enables the non-owner master to reply to ICMP echo requests directed at
the virtual router instances IP addresses.
799
policy
Creates VRRP control policies. 800
preempt
Provides the ability of overriding an existing non-owner master to the vir-
tual router instance.
800
Table 1: CLI Commands to Configure IES Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
