Virtual Private Routed Network Services
7750 SR OS Services Guide Page 891
Configure VPRN BGP parameters
909
config>service>vprn# bgp
advertise-inactive
Enables the advertising of inactive BGP routers to other BGP peers. 1063
aggregator-id-zero
Enables setting the router ID to zero in the aggregator path attribute
when BGP is aggregating routes.
1063
always-compare-med
Determines how the Multi-Exit Discriminator (MED) path attribute is
used in the BGP route selection process.
1064
as-path-ignore
Determines whether the AS path is used in determining the best BGP
route.
1064
authentication-key
Enables MD5 authentication and configures the authentication key. 1065
cluster
Configures the cluster ID for a route reflector server. 1066
connect-retry
Configures the BGP Connect Retry timer value in seconds. 1066
damping
Enables BGP route damping for learned routes as defined within the
route policy.
1067
description
Creates a text description for the BGP instance. 952
disable-client-reflect
Disables the reflection of routes by the route reflector to the clients in
the given peer group.
1067
disable-communities
Specifies BGP to disable sending communities. 1068
disable-fast-external-
failover
Configures BGP fast external failover. 1068
export
Specifies the export route policy to be used for determining which
routes are advertised to peers.
1068
hold-time
Configures the BGP Hold Time in seconds. 1070
ibgp-multipath
Allows BGP to use multiple BGP learned routes with different BGP
nexthops and also, to use ECMP routes to resolve the BGP nexthop
providing either load-balancing across the ECMP nexthops or install
the BGP route with all of the ECMP nexthops.
1070
import
Specifies the import route policy to be used for determining which
routes are accepted from peers.
1070
keepalive
Configures the BGP keepalive timer in seconds. 1071
local-as
Adds a BGP virtual AS number. 1072
local-preference
Enables setting the BGP local-preference attribute in incoming routes
if not specified and configures the default value for the attribute.
1073
loop-detect
Configures how the BGP peer session will handle loop detection in the
AS Path.
1073
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
