Configuring a VPRN Service with CLI
Page 892 7750 SR OS Services Guide
med-out
Enables advertising the Multi-Exit Discriminator (MED) and assigns
the value used for the path attribute for the MED advertised to BGP
Peers if the MED is not already set.
1074
min-as-origination
Configures the minimum interval in seconds at which a given path
attribute, originated by the local router, can be advertised to a peer.
1075
min-route-
advertisement
Configures the minimum interval in seconds at which a given prefix
can be advertised to a peer.
1075
multihop
Configures the TTL value entered in the IP header of packets sent to an
EBGP peer multiple hops away.
1076
multipath
Enables BGP multipath. When multipath is enabled BGP will load
share traffic across multiple links.
1076
preference
Configures the route preference for routes learned from the configured
peer(s).
1078
remove-private
Enables removing the private AS numbers from the AS Path before
advertising them to BGP peers.
1079
router-id
Configures the router ID to be used with this BGP instance. 967
no shutdown
Administratively enables BGP. 951
Configure group level VPRN BGP group parameters
910
config>service>vprn>bgp>group
advertise-inactive
Enables the advertising of inactive BGP routers to other BGP peers. 1063
aggregator-id-zero
Enables setting the router ID to zero in the aggregator path attribute
when BGP is aggregating routes.
1063
as-override
Replaces all instances of the peer's AS number with the local AS
number in a BGP route's AS_PATH.
1064
authentication-key
Enables MD5 authentication and configures the authentication key. 1065
cluster
Configure the cluster ID for a route reflector server. 1066
connect-retry
Configures the BGP Connect Retry timer value in seconds. 1066
damping
Enables BGP route damping for learned routes as defined within the
route policy.
1067
description
Creates a text description stored in the configuration file for a
configuration context.
952
disable-client-reflect
Disable the reflection of routes by the route reflector to the clients in
the given group.
1067
disable-communities
Specifies BGP to disable sending communities. 1068
disable-fast-external-
failover
Configures BGP fast external failover. 1068
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
