Virtual Private Routed Network Services
7750 SR OS Services Guide Page 893
export
Specifies the export route policy to be used for determining which
routes are advertised to peers.
1068
hold-time
Configures the BGP Hold Time in seconds. 1070
import
Specifies the import route policy to be used for determining which
routes are accepted from peers.
1070
keepalive
Configures the BGP keepalive timer in seconds. A keepalive message
is sent every time this timer expires.
1071
local-address
Configures the local IP address used by the group or neighbor when
communicating with BGP peers.
1072
local-as
Adds a BGP virtual AS number. 1072
local-preference
Enables setting the BGP local-preference attribute in incoming routes
if not specified and configures the default value for the attribute.
1073
loop-detect
Configures how the BGP peer session will handle loop detection in the
AS Path.
1073
med-out
Enables advertising the Multi-Exit Discriminator (MED) and assigns
the value used for the path attribute for the MED advertised to BGP
Peers if the MED is not already set.
1074
min-as-origination
Configures the minimum interval in seconds at which a given path
attribute, originated by the local router, can be advertised to a peer.
1075
min-route-
advertisement
Configures the minimum interval in seconds at which a given prefix
can be advertised to a peer.
1075
multihop
Configures the TTL value entered in the IP header of packets sent to an
EBGP peer multiple hops away.
1076
next-hop-self
Configures the group or neighbor to always set the NEXTHOP path
attribute to its own physical interface when advertising to an EBGP
peer.
1077
passive
Enables passive mode for the BGP group or neighbor. 1077
peer-as
Configures the autonomous system number for the remote peer. The
peer AS number must be configured for each configured peer.
1077
preference
Configures the route preference for routes learned from the configured
peer(s).
1078
prefix-limit
Configures the maximum number of routes BGP can learn from a peer. 1078
remove-private
Enables removing the private AS numbers from the AS Path before
advertising them to BGP peers.
1079
type
Configures the BGP peer as type internal or external. 1079
no shutdown
Administratively enables the BGP group. 951
Configure group level VPRN BGP neighbor parameters 910
config>service>vprn>bgp>group>neighbor
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
