Alcatel-Lucent 7750 SR OS - Page 895

Virtual Private Routed Network Services
7750 SR OS Services Guide Page 895
multihop
Configures the TTL value entered in the IP header of packets sent to an
EBGP peer multiple hops away.
1076
next-hop-self
Configures the group or neighbor to always set the NEXTHOP path
attribute to its own physical interface when advertising to an EBGP
peer.
1077
passive
Enables passive mode for the BGP group or neighbor. 1077
peer-as
Configures the autonomous system number for the remote peer. The
peer AS number must be configured for each configured peer.
1077
preference
Configures the route preference for routes learned from the configured
peer(s).
1078
prefix-limit
Configures the maximum number of routes BGP can learn from a peer. 1078
remove-private
Enables removing the private AS numbers from the AS Path before
advertising them to BGP peers.
1079
type
Configures the BGP peer as type internal or external. 1079
no shutdown
Administratively enables the BGP neighbor. 951
Configure VPRN RIP parameters 913
config>service>vprn# rip
authentication-key
Sets the authentication password to be passed between RIP neighbors. 1101
authentication-type
Defines the type of authentication to be used between RIP neighbors. 1102
check-zero
Enables checking for zero values in fields specified to be zero by the
RIPv1 and RIPv2 specifications.
1102
description
Creates a text description for the RIP instance. 952
export
Specifies the export policies to be used to control routes advertised to
RIP neighbors.
1103
import
Specifies the import policies to be used to control routes advertised
from RIP neighbors.
1103
message-size
Sets the maximum number of routes per RIP update message. 1104
metric-in
Sets the metric added to routes that were received from a RIP neighbor. 1104
metric-out
Sets the metric added to routes that were exported into RIP and
advertised to RIP neighbors.
1104
preference
Sets the route preference assigned to RIP routes. 1105
receive
Configures the type(s) of RIP updates that will be accepted and
processed.
1105
send
Specifies the type of RIP messages sent to RIP neighbors. 1106
split-horizon
Enables the use of split-horizon. 1102
timers
Sets the values for the update, timeout, and flush timers. 1106
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page