Virtual Private Routed Network Services
7750 SR OS Services Guide Page 897
metric-out
Sets the metric added to routes that were exported into RIP and
advertised to RIP neighbors.
1104
preference
Sets the route preference assigned to RIP routes. 1105
receive
Configures the type(s) of RIP updates that will be accepted and
processed.
1105
send
Specifies the type of RIP messages sent to RIP neighbors. 1106
split-horizon
Enables the use of split-horizon. 1102
timers
Sets the values for the update, timeout, and flush timers. 1106
Configure VPRN OSPF parameters
config>service>vprn# ospf
area
Creates the context to configure an OSPF area. 1081
area-range
Creates ranges of addresses on an Area Border Router (ABR) for the
purpose of route summarization or suppression.
1081
blackhole-aggregate
Installs a low priority blackhole route for the entire aggregate. 1082
interface
Creates a context to configure an OSPF interface. 1082
advertise-subnet
Enables advertising point-to-point interfaces as subnet routes (network
number and mask).
1083
authentication-key
Configures the password used by the OSPF interface or virtual-link to
send and receive OSPF protocol packets on the interface when simple
password authentication is configured.
1083
authentication-type
Enables authentication and specifies the type of authentication to be
used on the OSPF interface.
1084
dead-interval
Configures the time, in seconds, that OSPF waits before declaring a
neighbor router down.
1084
hello-interval
Configures the interval between OSPF hellos issued on the interface or
virtual link
1085
interface-type
Configures the interface type to be either broadcast or point-to-point. 1085
message-digest-key
Configures a message digest key when MD5 authentication is enabled
on the interface
1086
metric
Configures an explicit route cost metric for the OSPF interface that
overrides the metrics calculated based on the speed of the underlying
link
1087
mtu
Configures the OSPF packet size used on this interface 1087
passive
Adds the passive property to the OSPF interface where passive
interfaces are advertised as OSPF interfaces but do not run the OSPF
protocol.
1087
Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command Description Page
To Next Page
Loading...
