Programming Control
25.
Special Vend D Days Enable
"SPd-"
This option allows the owner to enable
or
disable a
fourth special vend.
Special Vend D can
be
programmed using an external
device or network.
The owner
may
also turn the Special Vend D option
on
or
off
if
desired.
How
to
Program Special Vend D Days
Enable
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2.
Press the DELICATESIBULKY
(A)
or
the
COLD
(v)
keypad until
"Prog"
appears in the
display. Press the START (enter) keypad and
"AtS
1"
will appear in the display.
3. Press the DELICATESIBULKY
(A)
or the
COLD
(v)
keypad to scroll through the
programmable options until
"SPd~"
appears in
the display.
4. When
"SPd~"
appears in the display, press the
START (enter) keypad.
The
current Special Vend
D Days Enable status will appear in the display.
"on"
= Option Enabled
"oFF"
= Option Disabled
(factory default setting)
5. Press the
DELICATESIBULKY
(A)
or the
COLD
(v)
keypad to change the current status.
6. Press the START (enter) keypad when the correct
status appears in the display.
The
next option,
"CnP~",
will appear in the display.
NOTE:
To
program "CnP·" (Cycle Modifier
Programming), refer to
option 26.
To
program
other options, refer to the appropriate section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad until the control returns
to Ready Mode.
70
© Published by pennission
of
the copyright owner - DO NOT
COpy
or
TRANSMIT
802952
To Next Page
Loading...
