Programming Control
26.
Cycle Modifier Programming
"CnP-"
This option allows the owner to program the machine
to offe
7
an added prewash, extra wash time, an added
extra nnse, a warm rinse,
or
any combination
of
the
above to the customers for
an
added vend price. This
option is selected when MEDIUM
or
HEAVY is
selected using the SOIL LEVEL keypad.
How
to
Program Cycle Modifier Medium
Price "CnP1"
This price setting will
be
added to the current vend
price. For example,
if
the vend price is $1.00
and
Cycle Modifier Medium Price is set to .25, the total
vend
price when the Medium Soil Level is chosen will
be
$1.25.
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad until
"Prog"
appears in the
display. Press the START (enter) keypad and
"AtS1" will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to scroll through the
programmable options until
"CnP·"
appears in
the display. Press the START (enter) keypad and
"CnP1"
will appear in the display.
4. When
"CnP1"
appears in the display, press the
START (enter) keypad. There are five digits in
the
Cycle Modifier Medium Price.
The
fifth digit
will appear
in
the display and will flash for one
second on, one second off. Refer to
Figure 24.
NOTE:
If
the vend price is $100.00
or
more, the
fifth digit is
"1-6".
Ifthe
vend price is $99.99
or
less,
the
fifth digit is
"0".
[
CHM507R
:
Figure 24
5. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to increase
or
decrease the
value
of
the fifth digit.
NOTE:
The
vend price
can
be set from 0 to 65,535.
The factory default setting is 25.
6. Press the START (enter) keypad to enter the fifth
digit
and
display remaining four digits.
The
active digit will flash one second
on
and one
second off.
NOTE:
To
go
back
to
the
current
programmable
option without changing the value, press
the
WARM
«)
keypad.
7. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to increase
or
decrease the
value
ofthe
active digit and the START (enter)
keypad to enter the value
of
the digit
and
advance
to the next digit.
8. Press the START (enter) keypad with the last
active digit.
The
next Cycle Modifier option,
"CnP2",
will appear in the display.
NOTE: To
program
"CnP2" (Cycle Modifier
Heavy Price), continue
to
next Cycle Modifier
option. To
program
other
options, press
the
WARM
«)
keypad
and
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the WARM «) keypad until the control returns
to Ready Mode.
802952
© Published
by
permission
of
the copyright owner - DO NOT COpy
or
TRANSMIT
71
To Next Page
Loading...
