30.
Low Power/Auto Shutdown B
Days Enable
"LPSb"
This option allows the owner to set Low Power/Auto
Shutdown
on
certain day(s)
of
the week. Low Power
or Auto Shutdown duration are programmed using an
external device
or
network.
How
to
Program the Low Power/Auto
Shutdown B Days Enable
1.
Control must
be
in
Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad until "Prog" appears in the
display. Press the START (enter) keypad and
"AtS1 " will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to scroll through the
programmable options until
"LPSb" appears
in
the display.
4. When
"LPSb" appears in the display, press the
START (enter) keypad. The current Low Power/
Auto Shutdown B Days Enable status will appear
in
the display.
"on"
= Option Enabled
"oFF"
= Option Disabled
(factory default setting)
5. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to change the current status.
6. Press the START (enter) keypad when the correct
status appears in the display. The next option,
"LPSC", will appear
in
the display.
NOTE:
To
program "LPSC" (Low Power/Auto
Shutdown C Days Enable), refer to
option 31.
To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
Press the WARM «) keypad until the control returns
to Ready Mode.
Programming Control
31.
Low Power/Auto Shutdown C
Days Enable "LPSC"
This option allows the owner to set Low Power/Auto
Shutdown on certain day(s)
of
the week. Low Power
or
Auto Shutdown duration are programmed using an
external device or network.
How
to
Program the Low Power/Auto
Shutdown C Days Enable
1.
Control must
be
in Manual Mode. Refer to
Entering the Manual Mode.
2.
Press the DELICATESIBULKY
(1\)
or the
COLD
(v) keypad until "Prog" appears
in
the
display. Press the START (enter) keypad and
"AtS
1"
will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to scroll through the
programmable options until
"LPSC" appears
in
the display.
4. When
"LPSC" appears in the display, press the
START (enter) keypad. The current Low Power/
Auto Shutdown C Days Enable status will appear
in
the display.
"on"
=Option Enabled
"oFF"
= Option Disabled
(factory default setting)
5. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad to change the current status.
6. Press the START (enter) keypad when the correct
status appears in the display. The next option,
"LPSd", will appear
in
the display.
NOTE:
To
program "LPSd" (Low Power/Auto
Shutdown D Days Enable), refer to
option 32.
To
program other options, refer to the appropriate
section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad until the control returns
to Ready Mode.
802952 @ Published by permission
of
the copyright owner - DO NOT COPY
or
TRANSMIT
79
To Next Page
Loading...
