Display Identification
Light Emitting Diodes (LEOs)
(Refer to
Figure
1)
LIGHT EMITTING DIODES (LEDs) are used to
indicate the chosen cycle, wash temperature, cycle
status and door lock information. See below for
information on each LED.
CYCLE LED (NORMAL, PERM PRESS
or
DELICATES/BULKY)
CYCLE LED will remain lit the entire cycle.
WASH TEMP LED (HOT, WARM or COLD)
WASH TEMP LED will remain on until the end
of
the
cycle
or
will
change to show the rinse temperature
if
programmed to do so.
WASH LED
WASHLED is lit at the beginning
of
a wash portion
of
the cycle and
will
remain lit until the wash is
complete.
RINSE LED
RINSE LED is lit at the beginning
of
a rinse portion
of
the cycle and will remain lit until
the
rinse is complete.
SPIN LED
SPIN
LED is lit during the Final Spin portion
of
the
cycle.
INSERT COINS/CARD LED
INSERT COINS/CARD LED prompts the user for
coins or a card to satisfy the vend price. Four digits
show the vend price remaining to
be
satisfied.
The
vend price displayed will decrease with each coin
inserted.
If
new options are selected during the
ftrSt
fill
step
of
the wash cycle and
it
requires additional vend,
the
INSERT COINS/CARD light will flash one
(I)
second on and one (1) second off, and the display will
show the vend price remaining to
be
satisfied.
DOOR LED
DOOR LED is lit whenever the door is locked.
The
door
can't
be
opened when this LED is lit.
LIGHT LED
UGHTLED
is
lit when the Light soil level
is
selected.
MEDIUM LED
MEDIUM LED is lit when the Medium soil level is
selected.
HEAVY LED
HEAVYLED is lit when the Heavy soil level is
selected.
Four 7-Segment Digits
The
7-SEGMENT DIGITS are used to display the
time remaining
in
a cycle, vend price, error messages
and descriptive codes. During diagnostic testing or
manual programming
of
the control, these digits will
display descriptive codes and values (as described in
Entering
the
Manual
Mode).
802952
© Published by permission
of
the copyright owner - DO
NOT
COPY
or
TRANSMIT
7
To Next Page
Loading...
