Washer Operation
Start
Up
Start Mode
When power is applied to the washer, the control will
display its software version as
"S
XX"
("XX"
is the
version number) for one second.
If
the control was not
powered down during a running cycle, it will enter the
Ready Mode.
Ready Mode
In
this mode
of
operation the display shows the current
selected cycle, temperature and soil level, and the full
current vend price for that cycle.
The
INSERT
COINS/
CARD
LED
is lit.
To start the cycle, the user
must
satisfy the vend price
and then press the START keypad.
The
user will
be
able to select a different cycle, soil
level
or
wash water temperature
by
pressing a cycle
pad when the machine is
in
the
ready mode
or
in the
first fill step.
Partial Vend Mode
The control enters this mode when part
of
the vend
price has been entered, but not enough vend is entered
to satisfy the vend price. The control will display the
remaining vend price needed to start the cycle and the
INSERT COINS/CARD LED is lit.
Additional Vend Mode
The control enters this mode
if
the first fill was
interrupted to change a cycle, temperature
or
soil level
that requires more money.
If
the vend price is not
satisfied within 1 minute, the washer control will
go
back to the first selection and
the
cycle will continue.
After the flISt fill, all key presses will
be
ignored,
allowing the washer to
go
through the complete cycle.
The
control enters this mode when the full vend price
is satisfied, the vend price is zero
or
the control is
in
OPL Mode.
The
START
pad
LED will flash one
(I)
second
on
and one
(I)
second off.
If
Start Mode is
entered because the vend price is satisfied
or
the
control is
in
OPL Mode, the display will show
"PUSH" for one second, "Strt" for one second and the
current cycle time for one second.
If
Start Mode is
entered because the vend price is zero, the display will
show "FREE",
When
first entering Start Mode, a
signal will sound for one (1) second
on
and one
(I)
second
off
for 10 seconds
if
Signal for Start is enabled.
After pressing the START keypad, the door
winlock
and the cycle will begin.
End
of
Cycle Mode
When a cycle is complete, the control will display
"00"
until the washer door is opened, a key is pressed, or a
coin/card is entered. When one
of
these three options
occurs, the display will revert back to the ready mode.
Cycle Sequence
Upon the start
of
a cycle, the control will display
the
total cycle time.
The
appropriate LEDs will light while
the machine passes through different cycle steps. Any
coin entered after the
fust
fill cycle will
be
added to
the total coin counter, but the user will not
be
able to
change cycles
or
water temperature.
Closing Washer Door
If
the door is not closed when the vend price is satisfied,
"door"
will
be
displayed until the door is closed. Once
door is closed, the START pad must
be
pressed to lock
door and start the cycle.
If
the door does not lock within
15
seconds
of
being closed, "E dL" will
be
displayed,
indicating a door lock error, while the door continues to
try
to lock.
If
the door locks after
15
seconds, the door lock error
will clear
and
the cycle will continue normally.
8
© Published
by
permission
of
the copyright
owner·
00
NOT COPY
or
TRANSMIT
802952
To Next Page
Loading...
