Signals
There
are
five
options
when
a signal can be used during
the
washer
operation.
These
five
options
are
listed
below:
L End
of
Cycle Signal
By
default,
this
signal
is turned
off.
If
turned
on,
the
signal sounds for three
(3)
seconds at the end
of
a
cycle.
2. Signal On Keypad Depression
By default, this signal
is
turned
on
and sounds
for
a quarter
of
a second each time a keypad
is
pressed.
3.
Signal On Coin Input/Card Insertion
By default, this signal is turned on and will sound
for a quarter
of
a second each time a coin or card
is
entered.
4.
Signal for Card Removal (Card Models Only)
By default, this signal
is
turned on and will sound
one second on and one second off when the
control
is
prompting for card removal.
5.
Signal for Start
By default, this signal is turned
on
and will sound
one second on and one second off for
10
seconds
after vend price has been satisfied.
NOTE: Refer to Programming
Control
to program
signal options.
Washer Operation
Changing Cycles
Cycles and wash temperatures can be changed anytime
during the first fill step. After the fIrst fill step, all key
presses are ignored.
Selecting a higher priced cycle,
wash
temperature or
soil
level
will pause
the
first
fill
step,
and
INSERT
COINS!
CARD
will
flash
one
(1)
second
on
and
one
(1)
second off
until the
vend
price has been
satisfied.
After
the
vend
price
has
been
satisfied,
the cycle will continue
with
the
new
selections.
If
the
vend
price
is
not satisfied within 1
minute,
the washer control will
go
back
to
the
previously set cycle, wash temperature and soil level.
802952 @ Published
by
permission
of
the copyright owner - DO NOT COPY
or
TRANSMIT
9
To Next Page
Loading...
