Entering the Manual Mode
For programming, testing, and retrieving infonnation
from the control, it is often necessary to enter the
Manual Mode
by
following the four simple steps below.
For an overview
of
entering the manual mode, refer to
the flowchart
on
the following page.
How to Enter the Manual Mode
1.
If
accessing Diagnostic Tests,
be
sure the washer
is in the Ready Mode before continuing to step
2.
If
the washer is in an active cycle, rapid advance
through the cycle. Refer to the
Rapid
Advance
Feature.
If
coins
or
a card has been entered, refer
to Clear Vend Feature.
2. Open the service door. Refer to Opening the
Service Door.
NOTE: The coin vault switch must be closed to
enter Manual Mode.
3. While pressing and holding the NORMAL
keypad with one hand, press the
HOT
keypad
with the other hand.
4. The display will show "rAPd".
5. Press the DELICATESIBULKY (1\)
or
the
COLD
(v)
keypad to scroll through the options
until the desired option appears in the display.
6. Press the START (enter) keypad.
NOTE: After entering
Manual
Mode,
if
no keypads
are
pressed for 4.25 minutes, the control
will
return
to the previous mode of operation.
7.
To
exit, press the WARM
«)
keypad. The control
will revert back to Ready Mode
Manual Mode is broken into three groups: Manual
Programming, Manual Rapid Advance and Manual
Diagnostics. Manual Programming can only
be
turned
on
or
off
with an external device
or
the network. Refer
to the appropriate instruction manual. Manual Rapid
Advance and Manual Diagnostics can
be
turned on and
offusing
an external device,
by
manual programming
(refer to options 35 and
36
of
Programming Contro/),
or
with the network.
By
default, all groups are turned "on".
The manual features available in each group are as
follows (the menu displayed on the display in this
mode is in parentheses).
Manual Programming
Manual Programming (Prog)
Manual Read Audit (AUdt)
Manual Reset (rSEt)
Manual Rapid Advance
Rapid Advance (rAPd)
Manual Diagnostics
Manual Diagnostic Tests (dIAg)
If
a group is turned off, the display will change from
the selected feature to
"oFF"
when the START
pad
is
pressed and an audio signal will sound for one second.
The
display will then return to the selected feature.
The
features in the group cannot
be
entered.
802952
© Published by permission
of
the copyright owner - DO NOT COPY
or
TRANSMIT
13
To Next Page
Loading...
