Programming Control
5.
Start Pulse Mode
"PLSn"
This option allows the owner to program the Start
Pulse Input. The Start Pulse Mode can
be
used for
after-market central
payor
card systems. The central
system sends the start pulse to the Start Pulse Input
of
the control to start the cycle.
If
set for single pulse, one
start pulse from the central system will start the cycle.
If
set for multiple pulses, each pulse will deduct from
the vend price value set up in
option 4 (Start Pulse
Value)
until the vend is satisfied.
How
to
Program Start Pulse Mode
1.
Control must be in Manual Mode. Refer to
Entering the
Manual
Mode.
2. Press the DELICATESIBULKY
(1\)
or
the
COLD
(v)
keypad until
"Prog"
appears in the
display. Press the START (enter) keypad and
"AtS1" will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to scroll through the
programmable options until
"PLSn" appears in
the display.
4. When
"PLSn" appears in the display, press the
START (enter) keypad.
"oFF"
or a number will
appear in the display. This number corresponds to
the current Start Pulse Mode Programming
Value.
5. Locate the desired number in the first column
of
Table
J below.
"PLSn"
Start Pulse
Mode Value
Start Pulse
ON/OFF
Single Pulsel
Multiple Pulses
"oFP'*
OFF
OFF
128
ON
Single Pulse
192
ON
Multiple Pulses
*Factory default setting.
Table
1
6. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to increase
or
decrease the
current number until correct.
NOTE:
To
go
back
to the
current
programmable
option without changing
the
current
value, press
the WARM
«)
keypad.
7. Press the START (enter) keypad when the correct
number appears in the display_
The
next option,
"AtyP", will appear in the display.
NOTE:
To
program
"AtyP"
(Available Type), refer
to
option
6.
To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad until the control returns
to Ready Mode.
28
© Published
by
permission
of
the copyright owner - DO NOT
COPY
or
TRANSMIT
802952
To Next Page
Loading...
