Programming Control
6.
Available
Type"
AtyP"
This option allows the owner to program when the
control provides an available output for card and
central pay systems.
How
to
Program Available Type
1.
Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2.
Press the DELICATESIBULKY
(1\)
or the
COLD (v) keypad until
"Prog" appears in the
display. Press the
START
(enter) keypad and
"AtS
1"
will appear in the display.
3.
Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to scroll through the
programmable options until
"AtyP" appears in
the display.
4. When
"AtyP" appears in the display, press the
START
(enter) keypad. A number will appear in
the display. This number corresponds to the
current Available Type Value.
S.
Press the DELICATESIBULKY
(1\)
or the
COLD (v) keypad to increase or decrease the
current number to the desired number selected
from
Table 2.
Available Type
Value
Mode(s)
in
Which Available
Signal
is
Active
0*
Ready Mode only
1
Ready Mode, Partial Vend Mode
2
Ready Mode, End
of
Cycle Mode
3 Ready Mode, End
of
Cycle Mode,
Partial Vend Mode
*Factory default setting.
Table
2
6.
Press the
START
(enter) keypad when the correct
number appears in the display. The next option,
"dCYC", will appear in the display.
NOTE: To
program
"dCYC"
(Default Cycle), refer
to
option
7.
To
program
other
options, refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the WARM
«)
keypad until the control returns
to Ready Mode.
7.
Default Cycle "dCYC"
This option allows the owner to set the default cycle
and temperature the machine will enter when in the
Ready Mode. When programming the default cycle,
refer to
Table 3.
How to Program Default Cycle
1.
Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2.
Press the DELICATESIBULKY
(1\)
or the
COLD (v) keypad until
"Prog" appears in the
display. Press the
START
(enter) keypad and
"AtS1 " will appear in the display.
3. Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to scroll through the
programmable options until "dCYC" appears in
the display.
4. When "dCYC" appears in the display, press the
START
(enter) keypad. A number will appear in
the display. This number corresponds to the
current default cycle value. The corresponding
LEDs also will be
lit. Refer to Table 3.
S.
Press the DELICATESIBULKY
(1\)
or the
COLD
(v)
keypad to increase or decrease the
current number
to
the desired number selected
from
Table 3.
6.
Press the
START
(enter) keypad when the correct
number appears in the display. The next option,
"oPL", will appear in the display.
NOTE:
To
program
"oPl"
(OPL
Mode), refer to
option 8. To
program
other
options,
refer
to
the
appropriate
section.
How
to
Exit Programming Feature
Press the
WARM
«)
keypad until the control returns
to Ready Mode.
802952
© Published
by
permission
of
the copyright owner - DO NOT
COpy
or
TRANSMIT
29
To Next Page
Loading...
