IMPORTANT
Damage to the opto-sensor due to
cleaning
To avoid damage to the sensors,
only clean the opto-sensor with the
supplied brush.
To avoid damage to the electronics,
never immerse the plug connector in
liquids when it is unplugged.
18. Remove the opto-sensor
.
19. Soak the opto-sensor for 1 minute.
20. Clean the opto-sensor with the supplied brush.
21. Rinse the opto-sensor with clear fresh water.
CMS-I-00002827
22. Insert the opto-sensor
.
CMS-I-00002826
9 | Repairing the machine
Maintaining the machine
MG6660-EN-II | D.1 | 27.09.2021
211
To Next Page
Loading...
