5. If the wrong track marker is lowered,
apply pressure to the "yellow" tractor control unit
once again.
The track marker is lifted and the shuttle valve
activates the opposite track marker.
6. Put the "yellow" tractor control unit in float
position.
The opposite track marker is lowered.
6.4.7.3.2 Adjusting the track marker
The overview shows the hole in which the telescopic
track marker is pegged.
CMS-I-00003876
1. Unfold the track markers.
2. Unlock the linch pin
.
3. Push the track marker arm
into the desired
position.
4. Lock the track marker arm with the linch pin.
5. Release the clamp connection
.
6. To adjust the track marker length,
move the shaft
of the track marker disc
to
the desired position.
7. To adjust the pitch of the track marker disc,
turn the shaft of the track marker disc to the
desired position.
CMS-I-00003875
CMS-T-00005444-A.1
6 | Preparing the machine
Preparing the implement for operation
MG6660-EN-II | D.1 | 27.09.2021
85
To Next Page
Loading...
