Connect Mode : C0 Disconn Mode: 00
Flush Mode : 00
*************** Expert *****************
TCP Keepalive : 45s
ARP cache timeout: 600s
*************** E-mail *****************
Mail server: 0.0.0.0
Unit :
Domain :
Recipient 1:
Recipient 2:
*** Trigger 1
Serial Sequence: 00,00
CP1: X
CP2: X
CP3: X
Message :
Priority: L
Min. notification interval: 0 s
Re-notification interval : 0 s
*** Trigger 2
Serial Sequence: 00,00
CP1: X
CP2: X
CP3: X
Message :
Priority: L
Min. notification interval: 0 s
Re-notification interval : 0 s
*** Trigger 3
Serial Sequence: 00,00
CP1: X
CP2: X
CP3: X
Message :
Priority: L
Min. notification interval: 0 s
Re-notification interval : 0 s
Change Setup:
0 Server configuration
1 Channel 1 configuration
3 E-mail settings
5 Expert settings
6 Security
7 Factory defaults
8 Exit without save
9 Save and exit Your choice ?
1. Type 0 (Server configuration) followed by Enter.
2. Type each part of the IP Address followed by Enter. If you do not want to change a value, just press Enter to
skip.
IP Address : (000) 10.(000) 0.(000) 0.(000) 254
3. If you wish to configure a Gateway, type Y and type each part of the Gateway Address followed by Enter,
otherwise type N.
Set Gateway IP Address (N) Y
Gateway IP addr (000) 10.(000) 0.(000) 0.(000) 201