AudioCodes Mediant 2600 - Page 17

Version 6.8 17 Mediant 2600 E-SBC
User's Manual Notices
Document Revision Record
LTRT Description
41599 Previous document release for Version 6.8.
41781 Screenshot updated for example of SIP message manipulation rules; available video
coders not based on license key; AupdHttpUserAgent parameter updated; RFC
updated for CDR Syslog message (RFC 3164); core dump procedure updated; HA
Settings page screenshot updated for configuring HA; CRP Normal mode routing rules
updated; software reset for DHCP trigger (not hardware reset); Feature Key not
required for IPv6; description for write-and-backup command revised;
mapping of logical
string names to physical ports (MAC address).
41782 PM_EnableThresholdAlarms parameter added; max. entries of TLS Contexts table;
Web Users table CLI commands updated; Web Users table parameter descriptions of
Session Limit and Session Timeout updated; IPv6 Feature Key removed; Internal DNS
table supports up to 3 (not 4) IP addresses per host name; remote UA behind NAT for
media section updated; MgmntLDAPGroups_Level parameter values updated; CRP
Normal mode preconfiguration updated; write-and-backup CLI command updated;
Ethernet Group section updated; PhysicalPortsTable_GroupStatus parameter updated;
EtherGroupTable_Mode (1RX/1TX removed and default changed); SIPR
ec note bulletin
for France added; IPGroup_SIPConnect parameter added;
SBCEnableAASTRASurvivabilityNotice replaced by SBCEnableSurvivabilityNotice; R-
factor note added; CDR terminator for RADIUS accounting added; WAN parameters
removed; dimensions corrected; descriptions of the following parameters were updated
- WebSessionTimeout; SRD_EnableUnAuthenticatedRegistrations;
DigitalOOSBehaviorForTrunk; DigitalOOSBehavior;
IpProfile_SBCRemoteReplacesBehavior; EnableSBCMediaSync
41786 The following parameters were updated: Version; Action Type; Port Range Start;
Number of Media Session Legs; Port Range End; UDP Port; SIP Group Name; UUI
Format; Classify By Proxy Set; Inbound Message Manipulation Set;
Outbound Message
Manipulation Set; Row Role; Disconnect on Broken Connection; Rate; Source IP
Address; Call Trigger; Group Policy; Max Generated Register Rate; RTP Base UDP
Port.
The following parameters were added: Generated Registers Interval; Network Node ID.
The following sub-sections were modified: Configuring RTP Base UDP Port; Avaya
UCID; Configuring IP Groups; Configuring SIP Message Manipulation; Configuring
Classification Rules; Configuring SBC IP-to-IP Routing; Automatic Configuration
Methods; FTP-based Provisioning; Automatic Update from Remote Servers; HA Ping
Parameters.
The following sub-sections were deleted: Configuring NFS Settings; NFS Parameters.
41792
 Updated sections: Configuring VoIP LAN Interface for OAMP (CLI); CLI-Based
Management (privileges); Understanding Configuration Modes (note); Configuring
Web User Accounts (typo); Configuring TLS Certificate Contexts (IPSec removed);
Assigning CSR-based Certificates to TLS Contexts (SHA); Generating Private Keys
for TLS Contexts (4096); Configuring the SEM Server (port removed, TLS added);
Configuring Proxy Sets (keep-alive); Configuring SBC IP-to-IP Routing; Configuring
SIP Response Codes for Alternative Routing Reasons; MAC Address Automatically
Inserted in Configuration File Name; Viewing Call Routing Status (removed);
Creating Core Dump and Debug Files upon Device Crash (reset)
 New sections: Viewing Proxy Set Status
 Updated parameters: NATTranslation_SourceStartPort;
NATTranslation_SourceEndPort; NATTranslation_TargetStartPort;
NATTranslation_TargetEndPort; IpProfile_SBCUseSilenceSupp; DisableSNMP;