AudioCodes Mediant 2600 - Page 272

User's Manual 272 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
Transport Type
CLI: voip-network proxy-ip >
transport-type
[ProxyIp_TransportType]
Defines the transport type for communicating with the Proxy
server.
 [0] UDP
 [1] TCP
 [2] TLS
 [-1] = Undefined
Note: If this parameter is not defined, the setting of the global
parameter SIPTransportType is used.
Proxy Name
CLI: proxy-name
[ProxySet_ProxyName]
Defines an arbitrary name to easily identify the Proxy Set.
The valid value is a string of up to 20 characters.
DNS Resolve Method
CLI: dns-resolve-method
[ProxySet_DNSResolveMethod]
Defines the DNS query record type for resolving the Proxy
server's host name into an IP address.
 [-1] = DNS resolving is done according to the settings of the
global parameter, Proxy DNS Query Type.
 [0] A-Record = (Default) A-record DNS query.
 [1] SRV = If the Proxy address is configured with a domain
name without a port (e.g., domain.com), an SRV query is
done. The SRV query returns the host names (and their
weights). The device then performs DNS A-record queries
per host name (according to the received weights). If the
configured Proxy address contains a domain name with a
port (e.g., domain.com:5080), the device performs a regular
DNS A-record query.
 [2] NAPTR = NAPTR query is done. If successful, an SRV
query is sent according to the information received in the
NAPTR response. If the NAPTR query fails, an SRV query is
done according to the configured transport type. If the
configured Proxy address contains a domain name with a
port (e.g., domain.com:5080), the device performs a regular
DNS A-record query. If the transport type is configured for
the Proxy address, a NAPTR query is not performed.
Note:
An SRV query can return up to four host names. For each
host name, the subsequent DNS A-record query can be
resolved into
up to 15 IP addresses. However, the device
supports up to 30 DNS-resolved IP addresses. If the device
receives more than this number of DNS-resolved IP addresses,
the device uses the first 30 IP addresses in the received list,
and ignores the rest.
Web/EMS: Enable Proxy Keep
Alive
CLI: voip-network proxy-set >
proxy-enable-keep-alive
[ProxySet_EnableProxyKeepAliv
e]
Enables the device's Proxy Keep-Alive mechanism, which
checks communication with the Proxy server.
 [0] Disable (default).
 [1] Using Options = Enables the Proxy Keep-Alive
mechanism using SIP OPTIONS messages. The device
sends these messages every user-defined interval,
configured by the 'Proxy Keep Alive Time' parameter. If the
device receives a SIP response code that is also configured
in the 'Keep-Alive Failure Responses' parameter (below), the
device considers the Proxy as down. You can also configure
whether to use the device's IP address or string name
("gateway name") in the OPTIONS message (see the
UseGatewayNameForOptions parameter).
 [2] Using Register = Enables the Proxy Keep-Alive