AudioCodes Mediant 2600 - Page 373

Version 6.8 373 Mediant 2600 E-SBC
User's Manual 21. SBC Configuration
Table 21-6: IP-to-IP Routing Table Parameter Descriptions
Parameter Description
Index
[IP2IPRouting_Index]
Defines an index number for the new table record.
Route Name
CLI: route-name
[IP2IPRouting_RouteName]
Defines an arbitrary name to easily identify the IP-to-IP
routing rule.
The valid value is a string of up to 20 characters. By default,
no value is defined.
Matching Characteristics - Rule
Source IP Group ID
[IP2IPRouting_SrcIPGroupID]
CLI: src-ip-group-id
Defines the IP Group from where the IP call was received.
Typically, the IP Group of an incoming SIP dialog is
determined (or classified) using the Classification table (see
Configuring Classification Rules on page 361).
The default is -1. To denote any IP Group, leave this field
empty.
Source Username Prefix
[IP2IPRouting_SrcUsernamePrefix]
CLI: src-user-name-prefix
Defines the prefix of the user part of the incoming SIP
dialog's source URI (usually the From URI). You can use
special notations for denoting the prefix. To denote calls
without a user part in the URI, use the $ sign. For available
notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 531.
The default is the asterisk (*) symbol (i.e., any prefix). If this
rule is not required, leave this field empty.
Source Host
[IP2IPRouting_SrcHost]
CLI: src-host
Defines the host part of the incoming SIP dialog's source
URI (usually the From URI).
The default is the asterisk (*) symbol (i.e., any host name). If
this rule is not required, leave this field empty.
Destination Username Prefix
[IP2IPRouting_DestUsernamePrefix]
CLI: dst-user-name-prefix
Defines the prefix of the incoming SIP dialog's destination
URI (usually the Request URI) user part. You can use
special notations for denoting the prefix. To denote calls
without a user part in the URI, use the $ sign. For available
notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 531.
The default is the asterisk (*) symbol (i.e., any prefix). If this
rule is not required, leave this field empty.
Destination Host
[IP2IPRouting_DestHost]
CLI: dst-host
Defines the host part of the incoming SIP dialog’s
destination URI (usually the Request-URI).
The default is the asterisk (*) symbol (i.e., any destination
host). If this rule is not required, leave this field empty.
Request Type
[IP2IPRouting_RequestType]
CLI: request-type
Defines the SIP dialog request type of the incoming SIP
dialog.
 [0] All (default)
 [1] INVITE
 [2] REGISTER
 [3] SUBSCRIBE
 [4] INVITE and REGISTER
 [5] INVITE and SUBSCRIBE

[6]
OPTIONS