AudioCodes Mediant 2600 - Page 374

User's Manual 374 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
Message Condition
[IP2IPRouting_MessageCondition]
CLI: message-condition
Assigns a SIP message Condition rule. To configure
Condition rules, see ''Configuring Message Condition Rules''
on page 367.
ReRoute IP Group ID
[IP2IPRouting_ReRouteIPGroupID]
CLI: re-route-ip-group-id
Defines the IP Group that initiated (sent) the SIP redirect
response (e.g., 3xx) or REFER message. This field is
typically used for re-routing requests (e.g., INVITEs) when
interworking is required for SIP 3xx redirect responses or
REFER messages. For more information, see ''Interworking
SIP 3xx Redirect Responses'' on page 337 and
''Interworking SIP REFER Messages'' on page 340,
respectively. This parameter functions together with the 'Call
Trigger' field (see below).
The default is -1 (i.e., not configured).
Call Trigger
[IP2IPRouting_Trigger]
CLI: trigger
Defines the reason (i.e, trigger) for re-routing the SIP
request:
 [0] Any = (Default) This routing rule is used for all
scenarios (re-routes and non-re-routes).
 [1] 3xx = Re-routes the request if it was triggered as a
result of a SIP 3xx response.
 [2] REFER = Re-routes the INVITE if it was triggered as
a result of a REFER request.
 [3] 3xx or REFER = Applies to options [1] and [2].
 [4] Initial only = This routing rule is used for regular
requests that the device forwards to the destination. This
rule is not used for re-routing of requests triggered by the
receipt of REFER or 3xx.
 [5] Broken Connection = If the device detects a broken
RTP connection during the call and the Broken RTP
Connection feature is enabled
(IpProfile_DisconnectOnBrokenConnection parameter is
configured to [2]), you can use this option as an explicit
matching characteristics to route the call to an alternative
de
stination. Therefore, for alternative routing upon broken
RTP detection, position the routing rule configured with
this option above the regular routing rule associated with
the call. Such a configuration setup ensures that the
device uses this alternative routing rule only when RTP
broken connection is detected.
Call Setup Rules Set Id
CLI: call-setup-rules-set-id
[IP2IPRouting_CallSetupRulesSetId]
Assigns a Call Setup Rule Set ID to the routing rule. The
device performs the Call Setup rules of this Set ID if the
incoming call matches the characteristics of this routing rule.
The device routes the call to the destination according to the
routing rule's configured action, only after it has performed
the Call Setup rules.
For configuring Call Setup rules, see ''
Configuring Call Setup
Rules'' on page 229.
Operation Routing Rule - Action
Destination Type
[IP2IPRouting_DestType]
CLI: dst-type
Determines the destination type to which the outgoing SIP
dialog is sent.
 [0] IP Group = (Default) The SIP dialog is sent to the IP
Group’s Proxy Set (SERVER-type IP Group) or
registered contact from the database (if USER-type IP