User's Manual 384 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
feature. This manipulation is for registration requests to
change the destination number of the secondary extension
numbers to the primary extension. For more information, see
''BroadSoft's Shared Phone Line Call Appearance for SBC
Survivability'' on page
346.
Source IP Group ID
CLI: src-ip-group-id
[IPInboundManipulation_SrcIp
Group]
Defines the IP Group from where the incoming INVITE is
received.
The default is -1 (i.e., any IP Group).
Source Username Prefix
CLI: src-user-name-prefix
[IPInboundManipulation_SrcUs
ernamePrefix]
Defines the prefix of the source SIP URI user name (usually in
the From header).
The default is the asterisk (*) symbol (i.e., any source username
prefix).
Note: The prefix can be a single digit or a range of digits. For
available notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 531.
Source Host
CLI: src-host
[IPInboundManipulation_SrcHo
st]
Defines the source SIP URI host name - full name (usually in the
From header).
The default is the asterisk (*) symbol (i.e., any host name).
Destination Username Prefix
CLI: dst-user-name-prefix
[IPInboundManipulation_DestU
sernamePrefix]
Defines the prefix of the destination SIP URI user name, typically
located in the Request-URI and To headers.
The default is the asterisk (*) symbol (i.e., any destination
username prefix).
Note: The prefix can be a single digit or a range of digits. For
available notations, see ''Dialing Plan Notation for Routing and
Manipulation'' on page 531.
Destination Host
CLI: dst-host
[IPInboundManipulation_DestH
ost]
Defines the destination SIP URI host name - full name, typically
located in the Request-URI and To headers.
The default is the asterisk (*) symbol (i.e., any destination host
name).
Request Type
CLI: request-type
[IPInboundManipulation_Reque
stType]
Defines the SIP request type to which the manipulation rule is
applied.
 [0] All = (Default) All SIP messages.
 [1] INVITE = All SIP messages except REGISTER and
SUBSCRIBE.
 [2] REGISTER = Only REGISTER messages.
 [3] SUBSCRIBE = Only SUBSCRIBE messages.
 [4] INVITE and REGISTER = All SIP messages except
SUBSCRIBE.
 [5] INVITE and SUBSCRIBE = All SIP messages except
REGISTER.
Manipulated URI
CLI: manipulated-uri
[IPInboundManipulation_Manip
ulatedURI]
Determines whether the source or destination SIP URI user part
is manipulated.
 [0] Source = (Default) Manipulation is done on the source SIP
URI user part.
 [1] Destination = Manipulation is done on the destination SIP
URI user part.
Operation Rule - Action
To Next Page
Loading...
Need help?
General
