User's Manual 386 Document #: LTRT-42060
Mediant 2600 E-SBC
The following procedure describes how to configure IP-to-IP Outbound Manipulation rules
in the Web interface. You can also configure these rules using the table ini file parameter,
IPOutboundManipulation or CLI command, configure voip > sbc manipulations ip-
outbound-manipulation.
To configure IP-to-IP outbound manipulation rules:
1. Open the IP to IP Outbound Manipulation page (Configuration tab > VoIP menu >
SBC > Manipulations SBC > IP to IP Outbound).
2. Click Add; the following dialog box appears:
Figure 21-14: IP to IP Outbound Manipulation Page - Add Dialog Box
3. Configure an IP-to-IP outbound manipulation rule according to the parameters
described in the table below.
4. Click Submit, and then save ("burn") your settings to flash memory.
Table 21-9: IP to IP Outbound Manipulation Table Parameter Description
Parameter Description
Index
[IPOutboundManipulation_Index
]
Defines an index number for the new table record.
Manipulation Name
CLI: manipulation-name
[IPOutboundManipulation_Manip
ulationName]
Defines an arbitrary name to easily identify the manipulation
name.
The valid value is a string of up to 20 characters. By default, no
value is defined.
Matching Characteristics - Rule
Additional Manipulation
CLI: is-additional-manipulation
[IPOutboundManipulation_IsAdd
itionalManipulation]
Determines whether additional manipulation is done for the
table entry rule listed directly above it.
[0] No = (Default) Regular manipulation rule - not done in
addition to the rule above it.
To Next Page
Loading...
