AudioCodes Mediant 2600 - Page 387

Version 6.8 387 Mediant 2600 E-SBC
User's Manual 21. SBC Configuration
Parameter Description

[1] Yes = If the previous table row entry rule matched the
call, consider this row entry as a match as well and perform
the manipulation specified by this rule.
Note: Additional manipulation can only be done on a different
item (source URI, destination URI, or calling name) to the rule
configured in the row above (configured by the 'Manipulated
URI' parameter).
Source IP Group ID
CLI: src-ip-group-id
[IPOutboundManipulation_SrcIP
GroupID]
Defines the IP Group from where the INVITE is received.
The default value is -1 (i.e., any IP Group).
Destination IP Group ID
CLI: dst-ip-group-id
[IPOutboundManipulation_DestI
PGroupID]
Defines the IP Group to where the INVITE is to be sent.
The default value is -1 (i.e., any IP Group).
Source Username Prefix
CLI: src-user-name-prefix
[IPOutboundManipulation_SrcUs
ernamePrefix]
Defines the prefix of the source SIP URI user name, typically
used in the SIP From header.
The default value is the asterisk (*) symbol (i.e., any source
username prefix). The prefix can be a single digit or a range of
digits. For available notations, see ''Dialing Plan Notation for
Routing and Manipulation'' on page 531.
Source Host
CLI: src-host
[IPOutboundManipulation_SrcH
ost]
Defines the source SIP URI host name - full name, typically in
the From header.
The default value is the asterisk (*) symbol (i.e., any
source host
name).
Destination Username Prefix
CLI: dst-user-name-prefix
[IPOutboundManipulation_DestU
sernamePrefix]
Defines the prefix of the destination SIP URI user name,
typically located in the Request-URI and To headers.
The default value is the asterisk (*) symbol (i.e., any destination
username prefix). The prefix can be a single digit or a range of
digits. For available notations, see ''Dialing Plan Notation for
Routing and Manipulation'' on page 531.
Destination Host
CLI: dst-host
[IPOutboundManipulation_DestH
ost]
Defines the destination SIP URI host name - full name, typically
located in the Request-URI and To headers.
The default value is the asterisk (*) symbol (i.e., any destination
host name).
Calling Name Prefix
CLI: calling-name-prefix
[IPOutboundManipulation_Callin
gNamePrefix]
Defines the prefix of the calling name (caller ID). The calling
name appears in the SIP From header.
The valid value is a string of up to 37 characters. By default, no
prefix is defined.
Message Condition
CLI: message-condition
[IPOutboundManipulation_Mess
ageCondition]
Assigns a Message Condition rule as a matching characteristic.
Message Condition rules define required SIP message formats.
For configuring Message Condition rules, see ''Configuring
Message Condition Rules'' on page 367.
Request Type
CLI: request-type
[IPOutboundManipulation_Requ
estType]
Defines the SIP request type to which the manipulation rule is
applied.
 [0] All = (Default) all SIP messages.
 [1] INVITE = All SIP messages except REGISTER and
SUBSCRIBE.

[2]
REGISTER = Only SIP REGISTER messages.