User's Manual 446 Document #: LTRT-42060
Mediant 2600 E-SBC
• On the toolbar, click Device Actions, and then choose Software Upgrade
Wizard.
Figure 30-3: Start Software Upgrade Wizard Screen
5. Click Start Software Upgrade; the wizard starts, prompting you to load a .cmp file:
Figure 30-4: Software Upgrade Wizard - Load CMP File
Note: At this stage, you can quit the Software Upgrade Wizard without having to reset
the device, by clicking Cancel . However, if you continue with the wizard and start
loading the cmp file, the upgrade process must be completed with a device reset.
6. Click Browse, and then navigate to where the .cmp file is located on your computer.
Select the file, and then click Open.
7. Click Load File; the device begins to install the .cmp file. A progress bar displays the
status of the loading process and a message informs you when file load successfully
completes.
To Next Page
Loading...
