AudioCodes Mediant 2600 - Page 541

Version 6.8 541 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description

Underline (_)
For example, "Private-comm_string1".
The default is "private".
Trap Community String
configure system > snmp trap >
community-string
[SNMPTrapCommunityString]
Defines the community string for SNMP traps.
The valid value is a string of up to 19 characters that can
include only the following:
 Upper- and lower-case letters (a to z, and A to Z)
 Numbers (0 to 9)
 Hyphen (-)
 Underline (_)
For example, "Trap-comm_string1".
The default is "trapuser".
SNMP Trusted Managers Table
Web: SNMP Trusted Managers
CLI: configure system > snmp >
trusted-managers
[SNMPTrustedMgr_x]
Defines up to five IP addresses of remote trusted SNMP
managers from which the SNMP agent accepts and processes
SNMP Get and Set requests.
Notes:
 By default, the SNMP agent accepts SNMP Get and Set
requests from any IP address, as long as the correct
community string is used in the request. Security can be
enhanced by using Trusted Managers, which is an IP
address from which the SNMP agent accepts and
processes SNMP requests.
 If no values are assigned to these parameters any
manager can access the device.
 Trusted managers can work with all community strings.
SNMP V3 Users Table
Web/EMS: SNMP V3 Users
CLI: configure system > snmp v3-
users
[SNMPUsers]
This parameter table defines SNMP v3 users. The format of
this parameter is as follows:
[SNMPUsers]
FORMAT SNMPUsers_Index = SNMPUsers_Username,
SNMPUsers_AuthProtocol, SNMPUsers_PrivProtocol,
SNMPUsers_AuthKey, SNMPUsers_PrivKey,
SNMPUsers_Group;
[\SNMPUsers]
For example:
SNMPUsers 1 = v3admin1, 1, 0, myauthkey, -, 1;
The example above configures user 'v3admin1' with security
level authNoPriv(2), authentication protocol MD5,
authentication text password 'myauthkey', and
ReadWriteGroup2.
For a description of this table, see ''Configuring SNMP V3
Users'' on page 76.