User's Manual 582 Document #: LTRT-42060
Mediant 2600 E-SBC
Parameter Description
Proxy servers even if the parameter DNSQueryType is
disabled.
Web/EMS: Use Gateway Name for
OPTIONS
CLI: use-gw-name-for-opt
[UseGatewayNameForOptions]
Determines whether the device uses its IP address or string
name ("gateway name") in keep-
alive SIP OPTIONS messages
(host part of the Request-URI). The "gateway name" is
configured using the SIPGatewayName parameter. The device
uses the OPTIONS request as a keep-alive message with its
primary and redundant SIP proxy servers (i.e., the
EnableProxyKeepAlive parameter is set to 1).
[0] No = (Default) Device's IP address is used in keep-alive
OPTIONS messages.
[1] Yes = Device's "gateway name" is used in keep-alive
OPTIONS messages.
[2] Server = Device's
IP address is used in the From and To
headers in keep-alive OPTIONS messages.
Web/EMS: Password
CLI: password-4-auth
[Password]
Defines the password for Basic/Digest authentication with a
Proxy/Registrar server. A single password is used for all device
ports.
The default is 'Default_Passwd'.
Web/EMS: Cnonce
CLI: cnonce-4-auth
[Cnonce]
Defines the Cnonce string used by the SIP server and client to
provide mutual authentication.
The value is free format, i.e., 'Cnonce = 0a4f113b'. The default
is 'Default_Cnonce'.
Web/EMS: Mutual Authentication
Mode
CLI: mutual-authentication
[MutualAuthenticationMode]
Determines the device's mode of operation when
Authentication and Key Agreement (AKA) Digest
Authentication is used.
[0] Optional = (Default) Incoming requests that don't include
AKA authentication information are accepted.
[1] Mandatory = Incoming requests that don't include AKA
authentication information are rejected.
Proxy IP Table
Web: Proxy IP Table
EMS: Proxy IP
CLI: configure voip > voip-network
proxy-ip
[ProxyIP]
This table parameter defines the Proxy Set table with Proxy
Set IDs, each with up to 10 Proxy server IP addresses (or
FQDN).
The format of the ini file table parameter is as follows:
[ProxyIP]
FORMAT ProxyIp_Index = ProxyIp_IpAddress,
ProxyIp_TransportType, ProxyIp_ProxySetId;
[\ProxyIP]
For a description of this table, see ''Configuring Proxy Sets'' on
page 269.
To configure the Proxy Set attributes (such as Proxy Load
Balancing) in the ini file, use the ProxySet parameter.
Proxy Set Table
Web: Proxy Set Table
EMS: Proxy Set
CLI: configure voip > voip-network
proxy-set
[ProxySet]
This table parameter defines the Proxy Set ID table. This
includes, for example, Proxy keep-
alive and load balancing and
redundancy mechanisms.
The format of the ini file table parameter is as follows:
[ ProxySet ]
FORMAT ProxySet_Index = ProxySet_ProxyName,
To Next Page
Loading...
