AudioCodes Mediant 2600 - Page 583

Version 6.8 583 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
ProxySet_EnableProxyKeepAlive,
ProxySet_ProxyKeepAliveTime,
ProxySet_ProxyLoadBalancingMethod,
ProxySet_IsProxyHotSwap, ProxySet_SRD,
ProxySet_ClassificationInput,
ProxySet_ProxyRedundancyMode,
ProxySet_DNSResolveMethod,
ProxySet_KeepAliveFailureResp,
ProxySet_SuccessDetectionRetries,
ProxySet_SuccessDetectionInterval,
ProxySet_FailureDetectionRetransmissions;
[ \ProxySet ]
For a description of this table, see ''Configuring Proxy Sets'' on
page 269.
For configuring the IP addresses per Proxy Set in the ini file,
use the ProxyIP parameter.
Registrar Parameters
Web/EMS: Registration Time
CLI: registration-time
[RegistrationTime]
Defines the time interval (in seconds) for registering to a Proxy
server. The value is used in the SIP Expires header. This
parameter also defines the time interval between Keep-Alive
messages when the parameter EnableProxyKeepAlive is set to
2 (REGISTER).
Typically, the device registers every 3,600 sec (i.e., one hour).
The device resumes registration according to the parameter
RegistrationTimeDivider.
The valid range is 10 to 2,000,000. The default is 180.
Web: Re-registration Timing [%]
EMS: Time Divider
CLI: re-registration-timing
[RegistrationTimeDivider]
Defines the re-registration timing (in percentage). The timing is
a percentage of the re-register timing set by the Registrar
server.
The valid range is 50 to 100. The default is 50.
For example: If this parameter is set to 70% and the
Registration Expires time is 3600, the device re-sends its
registration request after 3600 x 70% (i.e., 2520 sec).
Note: This parameter may be overridden if the parameter
RegistrationTimeThreshold is greater than 0.
Web/EMS: Registration Retry Time
CLI: registration-retry-time
[RegistrationRetryTime]
Defines the time interval (in seconds) after which a registration
request is re-sent if registration fails with a 4xx response or if
there is no response from the Proxy/Registrar server.
The default is 30 seconds. The range is 10 to 3600.
Web: Registration Time Threshold
EMS: Time Threshold
CLI: registration-time-thres
[RegistrationTimeThreshold]
Defines a threshold (in seconds) for re-registration timing. If
this parameter is greater than 0, but lower than the computed
re-registration timing (according to the parameter
RegistrationTimeDivider), the re-registration timing is set to the
following: timing set by the Registration server in the SIP
Expires header minus the value of the parameter
RegistrationTimeThreshold.
The valid range is 0 to 2,000,000. The default is 0.
Web: ReRegister On Connection
Failure
EMS: Re Register On Connection
Failure
Enables the device to perform SIP re-registration upon
TCP/TLS connection failure.
 [0] Disable (default)