Version 6.8 635 Mediant 2600 E-SBC
User's Manual 43. Configuration Parameters Reference
Parameter Description
CLI: ldap-private-nm-attr
[MSLDAPPrivateNumAttri
buteName]
Defines the name of the attribute that represents the user's private
number in the AD. If this value equals the value of the
MSLDAPPrimaryKey or MSLDAPSecondaryKey parameter, then
the device queries the AD for the destination number in this private
attribute name; otherwise, this parameter is not used as a search
key.
The default is "msRTCSIP-PrivateLine".
Web: MS LDAP DISPLAY
Name Attribute Name
CLI: ldap-display-nm-attr
[MSLDAPDisplayNameAtt
ributeName]
Defines the attribute name that represents the Calling Name in the
AD for LDAP queries based on calling number.
The valid value is a string of up to 49 characters. The default is
"displayName".
CLI: ldap-primary-key
[MSLDAPPrimaryKey]
Defines the name of the attribute used as a query search key for the
destination number in the AD. This is used instead of the "PBX"
attribute name (configured by the MSLDAPPBXNumAttributeName
parameter).
The default is not configured.
CLI: ldap-secondary-key
[MSLDAPSecondaryKey]
Defines the name of the attribute used as the second query search
key for the destination number in the AD, if the primary search key
or PBX search is not found.
LDAP Cache Service
CLI: cache
[LDAPCacheEnable]
Enables the LDAP cache service.
[0] Disable (default)
[1] Enable
Notes:
For this parameter to take effect, a device reset is required.
For more information on LDAP caching, see 'Configuring the
Device's LDAP Cache' on page 209.
LDAP Cache Entry Timeout
CLI: entry-timeout
[LDAPCacheEntryTimeout
]
Defines the duration (in minutes) that an entry in the LDAP cache is
valid. If the timeout expires, the cached entry is only used if there is
no connectivity with the LDAP server.
The default is 1200.
LDAP Cache Entry
Removal Timeout
CLI: entry-removal-
timemout
[LDAPCacheEntryRemova
lTimeout]
Defines the duration (in hours) after which the LDAP entry is
removed from the cache.
The default is 0.
LDAP Configuration Table
Web: LDAP Configuration
Table
CLI: configure voip > ldap >
ldap-configuration
[LdapConfiguration]
Defines the LDAP servers.
[ LdapConfiguration ]
FORMAT LdapConfiguration_Index =
LdapConfiguration_LdapConfServerIp,
LdapConfiguration_LdapConfServerPort,
LdapConfiguration_LdapConfServerMaxRespondTime,
LdapConfiguration_LdapConfServerDomainName,
LdapConfiguration_LdapConfPassword,
LdapConfiguration_LdapConfBindDn,
LdapConfiguration_LdapConfInterfaceType,
LdapConfiguration_Type, LdapConfiguration_MngmAuthAtt,
To Next Page
Loading...
